How To Tie A Necktie

Don't you wish you could find already-tied ties, that you can simply Velcro around your shirt collar? Putting on a tie is considered a dreaded task for some men, but it really doesn't have to be. Just follow these simple directions and you'll know exactly how to tie a tie in no time.

Give yourself a few extra minutes when tying a tie for the first time. Allow yourself time to re-tie the knot higher or lower until you get it the right length. Part of good grooming means paying attention to the details. Employers will notice and appreciate the effort.

When slipping the broad end through the knot, push a loop through with your finger, then pull the rest through. This helps keep the knot together.

Look for the spot on the tie where the narrow end becomes wider. This will often be the best place to pass the broad end over the narrow end. Try tying the tie with this widening section laying on top of the narrow end's knot spot. Even if it does not make the perfect knot for you, it gives you a good way of gauging the distance the second time around.

How to tie the Windsor knot: Wide and Triangular - best suited for spread collar shirts.

1. The wide end "A" should extend about 12 inches below narrow end "B". Cross wide end "A" over narrow end "B".

2. Bring wide end "A" up through loop between collar and tie; then back down.

3. Pull wide end "A" underneath narrow end "B" and to the left, and back through the loop again.

4. Bring wide end "A" across the front from left to right.

5. Pull wide end "A" up through the loop again.

6. Bring wide end "A" down through the knot in front.

7 . Using both hands, tighten the knot carefully and draw up to collar.

The knot should stay snug on top of the collar button. A tie that is too tight will creep up the collar, not to mention reddening your face and making it difficult to breathe! A loosened tie looks sloppy and is a sign that you are not paying attention. Tip! Save these instructions with your ties for easy access!